FlukeView Forms Software with cable

FlukeView Forms supports the following test tools:

• Fluke 1550B MegOhmMeter
• Fluke 1653 / 1653B / 1654B / 1662 / 1663 / 1664FC Electrical Installation Tester
• Fluke 180 series
• Fluke 287 and 289
• Fluke 45
• Fluke 53-II B and 54-II B
• Fluke 568 IR Thermometer
• Fluke 789 ProcessMeter
• Fluke 8808A
• Fluke 8845A/8846A
• Fluke 89-IV and 87-IV
• Fluke 975 AirMeter Test Tool
• Fluke 983 Particle Counter

The ability of FlukeView Forms to support multiple instruments enables the user to install and learn only one software application in order to use these multiple tools fully.

Select the appropriate model number below based upon your requirements:

* Obsolete
** For all instruments listed in table

FlukeView® Forms Basic (FVF-BASIC): Owners of Fluke 280 series, 180 series, 789 and 1550B, who do not need the full power of FlukeView forms, can use FlukeView® Basic version. Transfer data points from your meter to your PC and use the two standard, non-customizable forms to display your readings in table or graphical form. For a larger array of forms or to use FlukeView® Forms Designer to customize your forms, upgrade to FlukeView® Forms version 3.3 with FVF-UG.

FlukeView® Forms Upgrade (FVF-UG): You can expand the power of your Fluke Test Tools by upgrading from FlukeView Forms Basic with the FlukeView® Forms Software Upgrade.

With the FlukeView® Forms Software Upgrade you can:

Instantly review and compare data from up to 6 different meters on the same document - providing analysis capabilities that a meter alone can't provide.

Use the array of Upgraded analysis and reporting forms to display your data in tables, graphs or helpful diagrams;even leave notes on the forms to draw attention to a particular event.

Or use the FlukeView® Forms plus Designer to customize your reports or add your company logo.

 

* Obsolete
** For all instruments listed in table

Using FlukeView® Forms with Multimeters, Thermometers†, MegOhmeters and ProcessMeter™ tools

For the meters in the table below, you can measure and store hundreds of readings to the meter's internal memory, and then later download the information to FlukeView® Forms. For meters that do not have internal memory, such as the Fluke-187, Fluke-789 and the Fluke-45, you can take interactive readings while connected to your PC with FlukeView® Forms.

FlukeView® Forms also logs events to make analyzing your data easier. This unique method of data recording provides more detailed readings when the input signal changes significantly. The amount of signal change that will trigger an event can be adjusted to fit your specific test situation. The minimum, maximum and average of readings are recorded for each event. Logging sessions can also be configured so that data will be recorded over specific intervals (e.g., every 5 minutes or 30 seconds).

Using FlukeView® Forms with Fluke 1653B Installation tester†
Up to 500 test results can be stored in the Fluke 1653B installation tester. The data stored for each measurement consists of the test function, user selectable test conditions and unique references. The results can be uploaded for preparing professional reports. These reports can easily be customized to suit individual requirements as well as compliance with local regulations. Standard formats as well as localized forms for Germany (ZVEH), Austria (ÖVE) and Switzerland (electrosuisse, gem. NIV) are also available

† Not supported in FlukeView Forms Basic