6270A Embedded Software, Update by USB

The updating of embedded software should only be performed after given specific instructions to do so from Technical Support or a Fluke Calibration Authorized Service Center.

If the update isn't performed properly, your product may be inoperable until it is.

Updating the PCM (Pressure Control Module) firmware is a separate (but similar) process to updating the main firmware. Instructions for that are after the instructions for updating the main firmware.

Do not attempt to update the main controller firmware and PCM firmware at the same time because the PCM will not be updated.

To update the main firmware, click on the [Get Software] button above, complete the online form or login to this website, then download the zip file by clicking the 6270A v108USB.zip link. Extract the four files to a location on your computer. This is the group of files that will be copied/uploaded to the 6270A controller to update the main firmware.

• 6270A_main
• script6270
• checksum
• 6270A_gui

On the 6270A go to the , , , screen and verify that "RS232 Emulation" is set to "OFF". This will enable you to drag and drop the firmware files from your computer to the 6270A.

Connect a USB cable to the back panel USB connector on the 6270A and to the computer.

On the computer, drag and drop (or copy and paste) the group of downloaded files from the computer to the drive letter of the 6270A. If you are prompted to overwrite an existing file with the same name, overwrite the existing file.

Wait at least 1 minute, then turn off the 6270A controller by the main power switch on the back panel. Leave it off for one minute then turn it back on.

Wait for the controller to completely power up to the main screen, then go to the , , screen and verify that "Revision" is correct. Press to return to the main screen.

To update the PCM firmware, click on the [Get Software] button above, complete the online form or login to this website, then download the zip file by clicking the 6270 PCM v104 USB.zip link. Extract the three files to a location on your computer. This is the group of files that will be copied/uploaded to the 6270A controller to update the PCM firmware.

• 6270pcm.img
• Script6270
• checksum

On the computer, drag and drop (or copy and paste) the group of downloaded files from the computer to the drive letter of the 6270A. If you are prompted to overwrite an existing file with the same name, overwrite the existing file.

Wait at least 1 minute, then turn off the 6270A controller by the main power switch on the back panel. Leave it off for one minute then turn it back on.

Wait for the controller to completely power up to the main screen, verify that the PCM firmware updated successfully, go to the ‹Setup›, ‹Diagnostic›, ‹Control›, ‹Primary› screen and verify that "Revision" is correct (at the bottom right corner of the screen).

If you communicate with the controller by a USB COM port, go back to the , , , screen and change the "RS232 Emulation" back to "ON". Make sure that "Remote IF" is set to "Computer". If set to "Terminal", every command that you send will be echoed back.
Also see the 6270A Service Manual and on our Online Help Center.